Changes to Step #6

Edit by Jim Carter —

Edit approved by Jim Carter

Before
After
Unchanged

Step Lines

[title] Lean On Me
-[* 1] Support!!!! This section is very important when using support for your print where applicable. In this screenshot the support is turned off, but copying each setting value shown will ensure a great support structure, that produces great overhang/bridging layers. Pay close attention to the Infill Angles section.
+[* 1] Support!!!! This section is very important when using support for your print where applicable. In this screenshot the support is turned off, but copying each setting value shown will ensure a great support structure, that produces great overhang/bridging layers. Pay close attention to the Support Infill Angles section.