Changes to Step #2

Edit by Jim Carter —

Edit approved by Jim Carter

Before
After
Unchanged

Step Lines

[title] Extruder Setup
[* 1] The next few images will show the settings that are used for PLA that have fixed issues for many people. Copy each of the values to your printer's profile.
[* 1] The Extruder tab assumes that your printer has the stock .5mm nozzle installed.
-[* 1] On the Layer tab, pay attention to the settings for the first layer. The amount of top, bottom layers, along with the perimeters may vary depending on the print, as well as the layer height.
+[* 1] Pay special attention to the ***Retraction Vertical Lift*** section.