Changes to Step #2

Edit by SeeMeCNC —

Edit approved by SeeMeCNC

Before
After
Unchanged

Step Lines

[title] Adding your printer to MatterControl
[* 1] Open MatterControl and click the "Printers..." button and then click on the ***Add New Printer*** button.
-[* 1] You'll be presented with a Setup Wizard that will allow you to enter the Make & Model of the printer you're adding. In this case, you'll chose ***SeeMeCNC*** for the Make and ***Rostock MAX v3*** for the model. Note that if you're using the SeeMeCNC branded version of MatterControl, SeeMeCNC will be the only Make available.
+[* 1] You'll be presented with a Setup Wizard that will allow you to enter the Make & Model of the printer you're adding. In this case, you'll chose the one that best describes your printer.
+ [* 10] Note that if you're using the SeeMeCNC branded version of MatterControl, SeeMeCNC will be the only Make available.
+ [* 1] If you have an H2 printer, it has not yet been added to MatterControl as an option. Choose Orion instead. You will need to change the bed size in the Printer > Print Area settings of MatterControl.
+ [* 1] For the 178mm arms your bed size is: 140 x 140
+ [* 1] For the 290mm arms your bed size is: 200 x 200
[* 1] The next page of the Setup Wizard will ask to install a Communications Driver. If you installed one during the MatterControl install process, you don't need to install a driver here. For Mac & Linux users, no driver is required.