Changes to Step #10
Step Lines
| [title] Preparing the Next Connection | |
| - | [* black] Remove the wires from the Heat |
| + | [* black] Remove the wires from the Heat 1 - & + terminal. |
| [* black] Locate the Red and Black 26awg wire that you cut from the Hotend Whip. These wires are already inserted into a 4 pin latching housing. | |
| [* black] Strip approximately 10-15mm of insulation off of the black and red wires (with that are in the 4 pin latching housing). | |
| [* black] Strip approximately 10-15mm of insulation off of the wires that were previously in the Heat 0 - & + locations. |