Skip to main content

Changes to Step #5

Edit by SeeMeCNC

Edit approved by SeeMeCNC

Before
After
Unchanged

Step Lines

[title] Removing the RAMBo Board
+[* icon_note] disregard the black jumper wire in the middle of the RAMBo board shown in the picture.
[* black] Remove the end-stops from the RAMBo board one at a time. If they are not already labeled, please label them as you remove them. From left to right they should be labeled X Y Z
[* black] Remove the stepper motor wires from the RAMBo board one at a time. If they are not already labeled, please label them as you remove them. From left to right they should be labeled X Y Z _ E0 _