Changes to Step #17
Step Lines
| + | [title] Installing the PTFE tube in the Extruder |
|---|---|
| + | [* 1] You will now need to trim the PTFE length to fit the extruder. |
| + | [* 1] For the older EZStruder you will be trimming the PTFE so it seats in the bottom of the brass PTC fitting. |
| + | [* 1] For the newer EZR Struder, you will be trimming the PTFE so it seats in the bottom of the filament path in the EZR Struder body (Approximately 40mm from the end of the extruder). |
| + | [* 9] ***YOU MUST NOT USE SCISSORS. YOU MUST USE A SHARP BLADE SUCH AS A UTILITY OR HOBBY KNIFE.*** |
| + | [* 9] ***Measure Twice Cut Once!*** |
| + | [* 1] Seat the PTFE tube in the extruder once you have it cut to length. |
Image 1
No previous image
Added