Changes to Step #13

Edit by SeeMeCNC —

Edit approved by SeeMeCNC

Before
After
Unchanged

Step Lines

[title] Inserting the PTFE (Bowden) in the WHIP
[* 1] Measure 20mm from the top of the PTC Fitting (this is universal between EZ & EZR Struders)
[* 1] This is the entry point of the PTFE tube into the whip. You will need to compress the mesh loom at that point in order to separate it enough to get the PTFE enough room to gain access.
-[* 1] Once you have that PTFE started you will feed it through the whip until you are 80mm from the end of the whip (measured from the end of the 8 position pluggable connector)
-[* 1] At that 80mm mark the PTFE will exit the whips mesh loom. Pull out any remaining slack in the PTFE tube.
+[* 1] Once you have that PTFE started you will feed it through the whip until you are 200mm from the end of the whip (measured from the end of the 8 position pluggable connector)
+[* 1] At that 200mm mark the PTFE will exit the whips mesh loom. Pull out any remaining slack in the PTFE tube.