Changes to Step #5
Step Lines
| - | [* 1] Insert wisdom here. |
|---|---|
| + | [title] Removing the Existing Hotend Whip |
| + | [* 1] Pull the wires from the existing hotend whip through the base assembly, out the side with the extruder panel (removed) |
| + | [* 1] Remove the ball cup arms from the effector platform. To do so, gently pull the ball cup arm off of each ball joint. |
| + | [* 1] Perform this operation with all (6) arms. |
| + | [* 1] Be sure not to loose the tension springs that go between each set of arms. |