Changes to Step #54
Step Lines
| - | [title] Install Wire Tie |
|---|---|
| + | [title] Install Wire Tie (REV 5 Board ONLY) |
| + | [* 1] If you have received a REV6 accelerometer board, this step is NOT required. There is a connector for each fan on the board. After you get the hot end installed on the platform in step 56, you will find the best routing for the fan wires. |
| [* 1] Install a wire tie to secure the leads you just worked on to the ball joint. The wire tie will route through the channel in the ball joint platform as shown in the picture. | |
| [* 1] [https://youtu.be/-DCH6WVM2ts|Assembling the Hot End and Effector Platform] |