Changes to Step #51
Step Lines
| - | [title] Preparing the Splice |
|---|---|
| + | [title] Preparing the Splice (REV5 Boards ONLY) |
| + | [* 9] If you have received a REV6 accelerometer board, this step is NOT required. There is a connector for wach fan on the board. |
| [* 1] Locate the 1/8" Heat Shrink Tubing 30mm long. | |
| [* 1] Cut the heat shrink tubing in half | |
| [* 1] Insert each piece over the legs of one of the leads/plug that you cut off in recent steps. | |
| [* 1] Twist the three red fan leads together (the ones still connected to the fans) | |
| [* 1] Twist the three black fan leads together (the ones still connected to the fans) |