Changes to Step #50

Edit by geneb —

Edit approved by geneb

Before
After
Unchanged

Step Lines

[title] Preparing the Splice
-[* 9] READ ALL STEPS BEFORE PROCEEDING!
+[* 9] READ ALL STEPS BEFORE PROCEEDING! [https://youtu.be/k-XYTvhCHJY|Wiring the Effector Platform Fans for the Rostock MAX v3]
[* 1] You will be cutting the plug off of the shortest fan lead first. You want to cut the leads as close to the plug as possible.
[* 1] You will now cut the remaining (2) sets of fan leads to the same length as the first.
[* 9] DO NOT DISCARD THE LEAD AND PLUGS THAT YOU CUT OFF. THESE WILL BE USED WHEN INSTALLING THE RAMBO BOARD. THEY WILL BE ATTACHED TO THE 40mm BALL BEARING FAN ALLOWING IT TO PLUG INTO THE RAMBo BOARD.
[* 1] Strip approximately 5mm of insulation from each of the leads that you cut.