Changes to Step #49

Edit by David Blackwood —

Edit approved by SeeMeCNC

Before
After
Unchanged

Step Lines

[title] Fan Lead Routing
[* 1] We will now route the fan leads on the bottom of the ball joint platform.
[* 1] Begin with the (2) layer fans that are closest to the channel in the ball joint platform (indicated by the blue circle). You will want to GENTLY flex up the wire management tab with a flat tool such as the print removal tool supplied with your kit. You will route the leads of the (2) fans closest to the channel towards that channel.
-[* 1] Next you will route the leads of the layer fan farthest from the channel. These fan leads will go under 3 wire management tabs are they pass around the perimeter of the ball joint platform.
+[* 1] Next you will route the leads of the layer fan farthest from the channel. These fan leads will go under 3 wire management tabs as they pass around the perimeter of the ball joint platform.
[* 1] Press down (by hand) any of the wire management tabs that were flexed up for this step.