Changes to Step #36
Step Lines
| - | [title] Install 2 Pin Header for Fans |
|---|---|
| + | [title] Install 2 Pin Header for Fans (REV 5 Board only) |
| + | [* 1] If you have received a REV6 accelerometer board, this step is NOT required. |
| [* 1] Locate the (2) Header 2 Pin JST PH2.0 (26176) | |
| [* 1] Insert and orient the parts as shown in the picture. ++ ***The solid face of the plug should be facing towards the center of the hot end.***++ | |
| [* 1] Solder those two plugs (4 total solder points in place from the bottom side of the HE280 Hotend PCB board. | |
| [* 10] If you pinch the leads on the white connectors a tiny bit, they'll "grip" the PCB and make them easier to solder. |