Changes to Step #32

Edit by Matthew Connor —

Edit declined by SeeMeCNC

Before
After
Unchanged

Step Lines

[title] Routing the High Temp Insulated Wire
-[* 1] Flex the high temp insulated wire that is crimped onto the heater cartridge and insert it into the through hole on the HE280 Hotend PCB marked with a +
+[* 1] Flex the high temp insulated wire that is crimped onto the heater cartridge and insert it through the hole on the HE280 Hotend PCB indicated by the blue arrow in picture #1. On the opposite side of the board, this same hole is marked with a "+" symbol.
[* 10] The high temp insulated wire should extend through the PCB board with the insulation resting against the bottom of the board.
-[* 1] Insert the thermistor legs into the through holes on the HE280 Hotend PCB Board. (The through holes that are used are noted in the image by red arrows)The through holes that are used are located to the right of the text "Part +"
- [* 10] The PTFE tubing on the legs of the themistor should rest against the bottom of the HE280 Hotend PCB board. It is ok if the thermistor leads have a slight bow to them between the heater block and the PCB, this is actually preferred, so do not trim the PTFE/legs down from the stock length.
+[* 1] Insert the thermistor legs through the holes on the HE280 Hotend PCB Board indicated by the red arrows in picture #2. These holes are to the RIGHT of the text "Part +".
+ [* 10] The PTFE tubing on the legs of the themistor should rest against the bottom of the HE280 Hotend PCB board. It is ok if the thermistor leads have a slight bow to them between the heater block and the PCB. This bowing is actually preferred, so do not trim the PTFE/legs down from the stock length.