Changes to Step #30

Edit by Matthew Connor —

Edit declined by SeeMeCNC

Before
After
Unchanged

Step Lines

[title] Installing the HE280 Hotend PCB
-[* 1] Locate the HE280 Hotend PCB Board (71210) and the EZR Struder / Hot End PTC Adapter (70604)
-[* 1] Insert the EZR Struder / Hot End PTC Adapter through the hole in the center of the HE280 Hotend PCB Board
+[* 1] Locate the HE280 Hotend PCB Board (71210) and the EZR Struder / Hot End PTC Adapter (70604).
+[* 1] Insert the EZR Struder / Hot End PTC Adapter through the hole in the center of the HE280 Hotend PCB Board.
[* 10] The black plastic ring of the EZR Struder / Hot End PTC Adapter should be on the side of the HE280 Hotend PCB Board with the 8 pin connector (See Pic)
-[* 1] Hand tighten the EZR Struder / Hot End PTC Adapter in the heat sink against the HE280 Hotend PCB Board. Ensure that the tab of the board that notes: SeeMeCNC is parallel with the edge of the heater block noted in the image.
+[* 1] Ensure that the tab of the board with the text "SeeMeCNC" is parallel with the edge of the heater block as shown in the image. Then, hand-tighten the EZR Struder / Hot End PTC Adapter in the heat break against the HE280 Hotend PCB Board.