Changes to Step #28

Edit by Matthew Connor —

Edit declined by SeeMeCNC

Before
After
Unchanged

Step Lines

[title] Setting the Thermistor
-[* 1] Locate the M3 -.5 x 6mm Phillips Head PH Machine Screw (30317) and the #4 SAE Flat Washer (30449)
-[* 1] Insert the thermistor (glass bead end first) into the hole (closest to the heater cartridge) in the side of the heater block.
-[* 1] Insert the #4 washer onto the M3 screw (sharp edges facing the head of the screw), and then insert the screw into the hole (furthest from the heater cartridge) in the side of the heater block.
-[* 1] Fully Tighten.
+[* 1] Locate the M3 -.5 x 6mm Phillips Head PH Machine Screw (30317) and the #4 SAE Flat Washer (30449).
+[* 1] Insert the thermistor (glass bead end first) into the hole that is closest to the heater cartridge in the side of the heater block.
+[* 1] Place the #4 washer on the M3 screw (sharp edges facing the head of the screw), and then insert the screw into the hole that is furthest from the heater cartridge in the side of the heater block.
+[* 1] Fully tighten.