Changes to Step #28

Edit by SeeMeCNC —

Edit approved by SeeMeCNC

Before
After
Unchanged

Step Lines

-[* 1] Insert wisdom here.
+[title] Setting the Thermistor
+[* 1] Locate the M3 -.5 x 6mm Phillips Head PH Machine Screw (30317) and the #4 SAE Flat Washer (30449)
+[* 1] Insert the thermistor (glass bead end first) into the hole (closest to the heater cartridge) in the side of the heater block.
+[* 1] Insert the #4 washer onto the M3 screw, and then insert the screw into the hole (furthest from the heater cartridge) in the side of the heater block.
+[* 1] Fully Tighten.