Changes to Step #27

Edit by Matthew Connor —

Edit declined by SeeMeCNC

Before
After
Unchanged

Step Lines

[title] Preparing the Thermistor
-[* 1] Make a 90 degree bend at the end of the thermistor / PTFE Tube (the end with the glass bead) using a pair of needle-nose pliers.
- [* 1] To do this: Pinch the needle-nose pliers onto the edge PTFE that is covering the legs of the thermistor, and rotate the needle-nose pliers, making the 90 degree bend.
+[* 1] Using a pair of needle-nose pliers, make a 90 degree bend at the end of the thermistor / PTFE Tubes where they meet the glass bead.
+ [* 1] To make the 90 degree bend, pinch the needle-nose pliers onto the ends of the PTFE Tubes that cover the legs of the thermistor, and rotate the pliers.
[* 1] Compare your result with the picture.