Changes to Step #26

Edit by Matthew Connor —

Edit declined by SeeMeCNC

Before
After
Unchanged

Step Lines

[title] Prepare the Thermistor
-[* 9] Be careful with the Thermistor, it is a fragile component, if handled too rough it will break.
+[* 9] Be careful with the Thermistor as it is a very fragile component. If handled too roughly, it will break.
[* 10] Due to their fragile nature, for orders shipped after 9/27/16, we have included a spare thermistor in your HE280 Hotend kit.
-[* 1] Locate the Thermistor 100K (26141) and 100mm long Small PTFE Tube (26190)
-[* 1] Cut the 100mm long small PTFE tube in half. You will now have two pieces that are 50mm long each.
-[* 1] Insert the PTFE tubes over each of the legs of the thermistor. This tube should be fully inserted up to the glass bead on the thermistor.
+[* 1] Locate the Thermistor 100K (26141) and 100mm long Small PTFE Tube (26190).
+[* 1] Cut the 100mm long small PTFE tube in half. You will now have two pieces that are each 50mm long.
+[* 1] Insert each leg of the thermistor into its own PTFE tube. Each tube should be pushed fully up to the glass bead on the thermistor.