Changes to Step #23

Edit by Matthew Connor —

Edit declined by SeeMeCNC

Before
After
Unchanged

Step Lines

[title] Installing High Temp Fiberglass Insulated Wire
-[* 1] Slide the High Temp Fiberglass Insulated Wire (side with 10mm stripped, into the other end of the wire ferrule (inserted in the last step)
+[* 1] Slide the High Temp Fiberglass Insulated Wire, the side with 10mm stripped, into the other end of the wire ferrule (inserted in the previous step).
[* 10] You should insert the High Temp Fiberglass Insulated Wire until the insulation is flush with the end of the wire ferrule.
-[* 1] Crimp the wire ferrule. Do this in three steps, roughly locate the midpoint of the ferrule and crimp the upper portion (side with the heater cartridge lead), then the lower side (side with the high temp wire), and finally crimp one last time in the center of the ferrule.
+[* 1] Crimp the wire ferrule. Do this in three steps: roughly locate the midpoint of the ferrule and crimp the upper portion (side with the heater cartridge lead), then the lower side (side with the high temp wire), and finally, crimp one last time in the center of the ferrule.