Changes to Step #20
Edit by Matthew Connor —
Edit declined by SeeMeCNC
- Before
- After
- Unchanged
Step Lines
| [title] Inserting the Wire Ferrule | |
| - | [* 1] Slightly bend out the |
| + | [* 1] Slightly bend out the lead that is parallel to the heat break from both the heater cartridge and the thermal safety fuse. |
| [* 1] Slide the ferrule (with insulation installed) over the heater cartridge lead, and then manipulate the lead from the thermal safety fuse to get it inserted into the other end of the ferrule. | |
| [* 1] Straighten the leads back out so they are running nearly parallel with the heat sink, heat break, and nozzle. |