Changes to Step #17
Edit by Matthew Connor —
Edit declined by SeeMeCNC
- Before
- After
- Unchanged
Step Lines
| [title] Preparing to Make the Connection | |
| [* 1] Using a pair of needle nose pliers, bend the lead of the thermal safety fuse (the side with the black epoxy coating) at a 90 degree angle, making it parallel with the heat sink, heat break, and nozzle. | |
| - | [* 1] Perform the same operation with one of the |
| + | [* 1] Perform the same operation with one of the heater cartridge leads. |
| [* 10] Note that you may need to trim the lead of the thermal safety fuse so that the end of the lead comes even with the end of the red insulation sleeve. |