Changes to Step #14

Edit by SeeMeCNC —

Edit approved by SeeMeCNC

Before
After
Unchanged

Step Lines

+[title] Installing the Nozzle
[* 1] Locate the HE280 .5mm Brass Nozzle.
[* 1] Screw the nozzle into the bottom of the heater block until it makes contact with the heat break.
[* 9] On the next step, tightening the nozzle, be sure not to damage the heater cartridge with the 15mm or 5/8 wrench.
[* 1] Tighten the nozzle fully, using a 15mm or 5/8 wrench on the heater block and a 6mm or 1/4 wrench on the nozzle.