Changes to Step #14

Edit by SeeMeCNC —

Edit approved by SeeMeCNC

Before
After
Unchanged

Step Lines

-[* 1] Insert wisdom here.
+[* 1] Locate the HE280 .5mm Brass Nozzle.
+[* 1] Screw the nozzle into the bottom of the heater block until it makes contact with the heat break.
+[* 9] On the next step, tightening the nozzle, be sure not to damage the heater cartridge with the 15mm or 5/8 wrench.
+[* 1] Tighten the nozzle fully, using a 15mm or 5/8 wrench on the heater block and a 6mm or 1/4 wrench on the nozzle.