Changes to Step #13

Edit by David Van Winkle —

Edit approved by SeeMeCNC

Before
After
Unchanged

Step Lines

[title] Heater Block / Break / Sink
[* 1] Screw the heat break into the heater block approximately 4mm.
[* 10] It does not have anything to seat against yet, so will not be tight.
-[* 9] The most critical part of this step is that the you get the round cut out in the heat sink running parallel with the heater cartridge, and on the same side as the M3 -.5 x10mm screws (as shown in pic, indicated with two red arrows)
+[* 9] The most critical part of this step is that you get the round cut out in the heat sink running parallel with the heater cartridge, and on the same side as the M3 -.5 x10mm screws (as shown in pic, indicated with two red arrows)