Changes to Step #13

Edit by Matthew Connor —

Edit declined by SeeMeCNC

Before
After
Unchanged

Step Lines

[title] Heater Block / Break / Sink
[* 1] Screw the heat break into the heater block approximately 4mm.
-[* 10] It does not have anything to seat against yet, so will not be tight.
-[* 9] Screwing the heat break ~4mm deep is very important! The Nozzle should be able to go almost entirely into the heater block before getting stopped by the heat break.
-[* 9] The most critical part of this step is that you get the round cut out in the heat sink running parallel with the heater cartridge, and on the same side as the M3 -.5 x10mm screws (as shown in pic, indicated with two red arrows)
+[* 10] It does not have anything to seat against yet, so it will not be tight.
+[* 9] Screwing the heat break approximately 4mm deep is very important! The Nozzle should be able to go almost entirely into the heater block before getting stopped by the heat break.
+[* 9] The most critical part of this step is getting the round cut-out in the heat sink running parallel with the heater cartridge and on the same side as the M3 -.5 x10mm screws (as shown in the picture, indicated with two red arrows).