Changes to Step #8

Edit by Matthew Connor —

Edit declined by SeeMeCNC

Before
After
Unchanged

Step Lines

[title] Securing the Cable Mount Hub
[* 10] ***NOTE: This step is not performed for the H2 Delta printer or when upgrading Rostock Max v1/v2 or Orion Delta printers.***
-[* 1] Measure 32" from the end of the whip with the Pluggable 8 position Push-In Wire Terminal Plug and make a mark on the mesh loom (Applying a piece of tape works well)
-[* 1] Align the Cable Mount Hub (26220) with the mark. (The reference is the opposite of the threads on the cable mount hub, as shown in the pic)
-[* 1] Use your available tools to tighten the hub securely to the loom. (For this example a crescent wrench and vise grip was used)
-[* 10] You will be tightening this fitting nearly 100%. It is designed in such a way that the teeth that grip the wires/loom will not cause any harm to the wires/loom.
+[* 1] Measure 32" from the end of the whip with the Pluggable 8 position Push-In Wire Terminal Plug and make a mark on the mesh loom. (Applying a piece of tape works well.)
+[* 1] Align the Cable Mount Hub (26220) with the mark. (The reference point is opposite of the threaded end on the cable mount hub, as shown in the picture.)
+[* 1] Use your available tools to tighten the hub securely to the loom. (For this example, a crescent wrench and a vise grip was used.)
+[* 10] You will tighten this fitting nearly 100%. It is designed such that the teeth that grip the wires/loom will not cause any harm to them.