Changes to Step #8

Edit by SeeMeCNC —

Edit approved by SeeMeCNC

Before
After
Unchanged

Step Lines

[title] Securing the Cable Mount Hub
-[* 10] NOTE: This step is not required for the H2 Delta printer or when upgrading Rostock Max or Orion Delta printers.
+[* 10] ***NOTE: This step is not performed for the H2 Delta printer or when upgrading Rostock Max v1/v2 or Orion Delta printers.***
[* 1] Measure 32" from the end of the whip with the Pluggable 8 position Push-In Wire Terminal Plug and make a mark on the mesh loom (Applying a piece of tape works well)
[* 1] Align the Cable Mount Hub (26220) with the mark. (The reference is the opposite of the threads on the cable mount hub, as shown in the pic)
[* 1] Use your available tools to tighten the hub securely to the loom. (For this example a crescent wrench and vise grip was used)
[* 10] You will be tightening this fitting nearly 100%. It is designed in such a way that the teeth that grip the wires/loom will not cause any harm to the wires/loom.