Changes to Step #3
Step Lines
| [title] Install Mesh Loom | |
| - | [* 1] Insert the mesh loom over the end of the wires ***WITHOUT *** the connectors pre-installed. |
| + | [* 1] Use a bit of tape to group the wire ends together (on the end without connectors) in order to make it easier to route through the mesh loom. |
| + | [* 1] Insert the mesh loom over the end of the wires that you just taped. |
| [* 1] Feed the wires all the way through the mesh loom. | |
| [* 1] The picture shows this step complete. |