Skip to main content

Changes to Step #2

Edit by geneb

Edit approved by geneb

Before
After
Unchanged

Step Lines

[title] Disassembling the Hot End
[* 1] Cut the Layer fan wires where you soldered them together during the build. Mark the ends coming from the wiring loom as "Layer" so you can identify them later.
[* 1] Cut the PEEK fan wires where you soldered them together during the build. Mark the ends coming from the wiring loom as "PEEK" so you can identify them later.
[* 1] Measure 1-1/4" from the top of the melamine hot end mount and cut the four wires leading to the hot end.
[* 1] Using your Phillips screwdriver & 5/16" wrench, remove the three screws that hold the hot end to the effector platform.
+[* 1] We're now ready to start adding connectors!