Changes to Step #1
Step Lines
| + | [title] Hardware required for the project. |
|---|---|
| [* 1] The photos in this step show you the hardware you'll need before you can begin work. | |
| [* 1] Image #1 shows the three #6-32 thumbscrews, 1" threaded standoffs and the three #6-32 x 3/8" screws used to attach the standoffs to the effector platform. | |
| [* 1] Image #2 shows the required male & female JST connectors that will be used to wire up the PEEK and layer fans. | |
| [* 1] Image #3 shows the 4 pin latching connectors that are used to wire up the hot end power and thermistor connections. |