Skip to main content

Changes to Step #1

Edit by geneb

Edit approved by geneb

Before
After
Unchanged

Step Lines

+[* 1] The photos in this step show you the hardware you'll need before you can begin work.
+[* 1] Image #1 shows the three #6-32 thumbscrews, 1" threaded standoffs and the three #6-32 x 3/8" screws used to attach the standoffs to the effector platform.
+[* 1] Image #2 shows the required male & female JST connectors that will be used to wire up the PEEK and layer fans.
+[* 1] Image #3 shows the 4 pin latching connectors that are used to wire up the hot end power and thermistor connections.

Image 1

No previous image

New image

Added

Image 2

No previous image

New image

Added

Image 3

No previous image

New image

Added