| + | [title] Software Install, Setup, and How to Operate your new 3D Printer |
|---|
| + | [* 1] Go to www.seemecnc.com/downloads and download Rostock Max v2 Users Manual |
|---|
| + | [* 1] Familiarize yourself with the READ ME FIRST section on page 2 |
|---|
| + | [* 1] Perform the driver installation as instructed on pages 5-6 |
|---|
| + | [* 1] YOU DO NOT NEED TO PERFORM THE STEPS ON PAGES 7-12. THE PRINTER'S FIRMWARE IS ALREADY LOADED ONTO THE RAMBO BOARD. |
|---|
| + | [* 1] Familiarize yourself with the LCD and Front Panel Controls on pages 13-15 |
|---|
| + | [* 1] Install and configure MatterControl as directed on pages 17-22 |
|---|
| + | [* 1] YOU DO NOT NEED TO PERFORM THE INITIAL FUNCTION TESTS ON PAGES 23-35. YOUR PRINTER IS ALREADY FULLY CONFIGURED AND CALIBRATED |
|---|
| + | [* 1] Get some practice printing! Pages 36-42 in the manual will teach you how to print a fan shroud on your new printer. This part is already installed on your printer, however this will be good practice for learning how to operate the software and printer. |
|---|