Changes to Step #10
Edit by Andy Oprisko —
Edit approved by Andy Oprisko
- Before
- After
- Unchanged
Step Lines
| + | [title] Just Slice & Print |
|---|---|
| + | [* 1] Just slice and print. Don't change a thing. Drop an STL into Cura and click "Prepare", then "Save to File". |
| + | [* 1] Cura expert mode has about a zillion combinations of choices, so it's tricky no matter how good your are. We've invested some time to make general purpose profiles to slice most parts. Try them before adjusting anything. |
| + | [* 1] Standards for SeeMeCNC Delta's for Cura 4-2-1, single or dual extrusion: |
| + | [* 1] Filament starts 160mm above nozzle |
| + | [* 1] Bed probing using macros we write "Probe Autolevel" |
| + | [* 1] Probe with hotend room temp and bed hot |
| + | [* 1] Only check box "support" or "dual extrusion" when getting started |