Changes to Step #1

Edit by Andy Oprisko —

Edit approved by Andy Oprisko

Before
After
Unchanged

Step Lines

[title] Install Cura
[* 1] For SeeMeCNC printers, we're currently using a master copy of Cura and regularly updating slicing profiles. This is the official SeeMeCNC recommended slicing software.
[* 10] We have updated to use the Cura 4.5 (currently in beta) because the results are good and they have finally included shared heater on the machine profile page.
-[* 1] Go [https://github.com/Ultimaker/Cura/releases/tag/v4.5-beta|HERE]for the cura setup files. Scroll to the bottom and select the file for the operating system you are using.
+[* 1] Go [https://ultimaker.com/software/ultimaker-cura|HERE]for the cura setup files. Download Cura 4.5
[* 1] Run the file you downloaded based on your operating system.
[* 1] Installation will begin, follow the software installation instructions. Our recommendation is to select all optional file types during installation.
[* 1] As general practice, a Windows restart is preferred when the installation is finished.