Changes to Step #2
Edit by Andy Oprisko —
Edit approved by Andy Oprisko
- Before
- After
- Unchanged
Step Lines
| + | [title] Fixing homing issue |
|---|---|
| + | [* 1] If when you attempted to home the machine, the machine only moved down a bit, you will first want to shut the machine off for 30 seconds and turn it back on to reset it. |
| + | [* 1] With the machine back on, manually raise the carriages to the top of the machine so the carriages are near the home position. See pic 1. |
| + | [* 1] Click the knob on the LCD and go back to Advanced menu and click the knob. Then scroll to Calibrate Z Height and click the knob. |
| + | [* 1] On this menu go directly to Z Position and click the knob. See Pic 2. |
| + | [* 1] Now scroll the knob to lower the carriages down to bring the nozzle closer to the bed. |
| + | [* 1] When the nozzle is close to the bed, click the knob and go to Set new Z=0.00 and click the knob. The LCD should beep. See Pic 3. |
| + | [* 1] Now scroll to Home towers and the machine should now be able to home to the top of the machine properly. You can now move to the next step. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added