Changes to Step #15

Edit by Tim Koscielny —

Edit approved by Tim Koscielny

Before
After
Unchanged

Step Lines

[title] Adjust Printer Height in the Firmware
[* 1] Re-install all the covers on the machine.
[* 1] Plug in the machine and turn it on.
[* 1] Follow these guides and decrease the printer height in your firmware by 23mm:
- [* 1] [guide|134|RAMBo]
+ [* 1] [https://drive.google.com/file/d/1UFV9SGV4262_RZLUqH_6v3s2grH70-4z/view?usp=drive_link|RAMBo]
[* 1] DuetWifi
-[* 1] [guide|103|After changing the machine height in the firmware, follow this guide to fully re-calibrate your printer.]
+[* 1] [https://drive.google.com/file/d/133R72n_ApYWTnf1sOWUcFMfIu_R1sqt8/view?usp=drive_link|After changing the machine height in the firmware, follow this guide to fully re-calibrate your printer.]
[* 9] Note: Make sure the probing speed in your "First Probe" macro is set to F800 in both locations shown in the photo!