Changes to Step #13
Edit by Caleb Fairres —
Edit approved by Caleb Fairres
- Before
- After
- Unchanged
Step Lines
| [title] Installing the Bed Wiring (cont'd) | |
| [* 1] Pass the silicone heater wires through the existing plastic bed insulator as shown. | |
| - | [* 1] Strip the wires from the heater and attach one of the wires to the black wire leading from the SSR terminal number 2, using the large wire splice connector |
| + | [* 1] Strip the wires from the heater and attach one of the wires to the black wire leading from the SSR terminal number 2, using the large wire splice connector |
| [* 1] Attach the other white wire to the white wire leading from N on the power supply | |
| [* 1] Plug in the SL connector you installed on the thermistor leads to the SMC1 thermisor board | |
| [* 1] Apply electrical tape to the white wires coming from the silicone heater as shown to cover the wires when folded back towards the bed. |