Skip to main content

Changes to Step #8

Edit by Caleb Fairres

Edit approved by Caleb Fairres

Before
After
Unchanged

Step Lines

+[title] Preparing the Bed
+[* 1] Clean the back of the aluminum heat spreader with alcohol and a paper towel.
+[* 1] Peel the backing off of the adhesive on the ***58801 Silicone Heater 300mm Dia 350W REV B***
+[* 1] Apply the heating pad, aligning the three notches with the deeper grooves on the heat spreader, and the white AC wires exiting from the right of the bed, as shown in the photo.

Image 1

No previous image

New image

Added

Image 2

No previous image

New image

Added