Changes to Step #4

Edit by Tim Koscielny —

Edit approved by Tim Koscielny

Before
After
Unchanged

Step Lines

[title] Drill Bed Mounting Holes
[* 1] Place the new ***84671 RMAXv4 Heat Spreader Laser Etched*** as shown to position holes.
+ [* 10] Note: counter sinking the mounting and thermistor holes is not necessary (as pictured).
[* 9] Make sure the heat spreader is lined up with the hole where the bed glass previously sat as perfectly as possible before continuing!
[* 1] Use the 4mm (5/32") drill to make holes in the three places shown for later bed mounting