Changes to Step #4
Edit by Caleb Fairres —
Edit approved by Caleb Fairres
- Before
- After
- Unchanged
Step Lines
| [title] Drill Bed Mounting Holes | |
| - | [* 1] Place new heat spreader as shown to position holes. |
| - | [* 1] Use the 4mm (5/32") drill in three places shown for bed mounting |
| + | [* 1] Place the new aluminum heat spreader as shown to position holes. |
| + | [* 9] Make sure the heat spreader is lined up with the hole where the bed used to sit as perfectly as possible before continuing! |
| + | [* 1] Use the 4mm (5/32") drill to make holes in the three places shown for later bed mounting |