Changes to Step #31
Edit by Caleb Fairres —
Edit approved by Caleb Fairres
- Before
- After
- Unchanged
Step Lines
| + | [title] Brown Wire Connection |
|---|---|
| + | [* 1] The brown wire exiting the Z tower with NO connector on it will install in the only empty clamp on the relay. |
| + | [* 9] You may need to strip a little extra of the sheathing off this wire. |
| + | [* 1] Unscrew the clamp on the relay just enough to insert the wire. |
| + | [* 1] Insert the wire as close to the center of the clamp where the screw is as possible, then tighten the screw to clamp the metal plate down on the wire. |
| + | [* 9] Make sure not to tighten the screw too much! |
| + | [* 1] You're now done with the top wire connections! |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added