Changes to Step #18
Edit by Caleb Fairres —
Edit approved by Caleb Fairres
- Before
- After
- Unchanged
Step Lines
| + | [title] Installing the Z Tower |
|---|---|
| + | [* 1] You will now install the Z tower, similarly to how you installed the X tower. The Z tower is the one in which you previously ran wires down. Start by making sure the end-stop legs are folded over. |
| + | [* 1] Begin by measuring the length of the wires that exit the Z tower. You will want to have 1 foot of wire exiting the tower at the bottom. Make the adjustment of the wires now. |
| + | [* 1] As you did before, grasp all the wires at the top of the tower (the end with the stepper motor) fold them into the relief in the T-Slot and hold to give them some memory. |
| + | [* 1] Feed the wires into the opening in the side of the upper assembly. This is the opening that is the opposite of the name badge (front of the printer). |
| + | [* 1] Slide the tower into the opening as you did with the X tower. |
| + | [* 9] Make sure to look from the outside of the tower towards the center of the upper assembly and ensure that the wires are ALL in their relief. |
| + | [* 1] Attach the tower to the upper assembly using 2 each of the provided 1/4-20 x 1" long button head screws, split ring washer, and flat washer. Fully Tighten. |
Image 1
No previous image
Added