Changes to Step #48
Edit by Caleb Fairres —
Edit approved by Caleb Fairres
- Before
- After
- Unchanged
Step Lines
| + | [title] Installing the Bowden Tube |
|---|---|
| + | [* 1] The Bowden Tube is the clear tube that delivers the filament from the extruder (EZR Struder) to the hot end (SE300). |
| + | [* 1] Bunch the mesh loom up approximately 100mm from the top of the extruder and insert the Bowden Tube. |
| + | [* 1] Push the Bowden Tube through the whip until you feel it 25-50mm from the "Y" in the whip. |
| + | [* 1] Bunch the mesh loom up near where you feel the Bowden Tube and push the tube out through the loom. |
| + | [* 9] Contrary to the second photo, do not insert the Bowden Tube into the hot end yet. |
Image 1
No previous image
Added
Image 2
No previous image
Added