Changes to this Step
Edit by Caleb Fairres —
Edit approved by Caleb Fairres
- Before
- After
- Unchanged
Step Lines
| + | [title] Wire Connections |
|---|---|
| + | [* 1] Route the thermistor wires (2 white wires) from the Z tower over the braided wires coming from the aluminum heat spreader (this is the bed thermistor). |
| + | [* 1] Cut and strip the thermistor wires from the Z tower 1.5 inches beyond the white toggle connector. |
| + | [* 1] Insert the thermistor wires into each side of the white toggle connector by pressing on one paddle at a time and inserting the wire. |
| + | [* 1] Please also ensure at this time that the thermistor leads are installed in the other side of the toggle connector. |
Image 1
No previous image
Added
Image 2
No previous image
Added