Changes to this Step
Edit by Caleb Fairres —
Edit approved by Caleb Fairres
- Before
- After
- Unchanged
Step Lines
| + | [title] Wire Connections |
|---|---|
| + | [* 1] The two remaining wires from the X tower are red and black 18awg and DO NOT have connectors. These are for the E0 Heat. |
| + | [* 1] You will install these wires in the Wago Connectors that are attached to the top of the power supply. |
| + | [* 1] Black to Black & Red to Red. |
| + | [* 10] If you are having trouble getting these wires to reach you may need to get feed some of the whip back into the tower (in the hole in the side of the X Tower) to provide enough length for these wires. |
| + | [* 1] Lift up on the orange lever on the Wago connector without a wire in it and insert the wire all the way until it stops. Then flip the lever down. This will secure the wire. Repeat for the other wire. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added