Changes to Step #13
Edit by Caleb Fairres —
Edit approved by Caleb Fairres
- Before
- After
- Unchanged
Step Lines
| + | [title] Preparing to Install Towers |
|---|---|
| + | [* 1] We will now begin to prepare the top of the machine to install the towers. |
| + | [* 9] ***IF YOUR ARTEMIS 300 HAS SCREWS HOLDING THE TOP OR BOTTOM DO NOT USE ANY POWER TOOLS! USE ONLY A SCREWDRIVER!*** |
| + | [* 1] If screws are holding the top on, carefully remove them with a screwdriver. Alternately your top could be secured with plastic rivets and is held together for shipping with shrink wrap. |
| + | [* 1] There is a fan installed on the cover. Current machines have this connector already installed. If not, it will need a connector installed on the leads. You will use a 2 pin KK connector. Install the red wire in PIN 1 and the black wire in PIN 2. |
| + | [* 1] You can now set the cover aside. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added