Changes to Step #11
Edit by Caleb Fairres —
Edit approved by Caleb Fairres
- Before
- After
- Unchanged
Step Lines
| + | [title] Installing Connectors on Stepper Motors |
|---|---|
| + | [* 9] Current machines will have the motor connectors already installed. Newest machines will have Red, Green, Yellow, and Blue wires instead of what is shown. |
| + | [* 1] The wires of the motion stepper motors will install into Molex KK 4 pin connectors. These wires will install into the connectors similarly to how previous wires were installed into the KK connectors. |
| + | [* 10] ***PIN 1 is indicated with a "1" on the connector. It is difficult to see if you are not looking at it closely, but it is there. *** |
| + | [* 1] Blue wire: Pin 1 |
| + | [* 1] Red wire: Pin 2 |
| + | [* 1] Green wire: Pin 3 |
| + | [* 1] Black wire: Pin 4 |
| + | [* 1] Perform this operation on all 3 stepper motors installed on the towers. |
Image 1
No previous image
Added
Image 2
No previous image
Added