Changes to Step #10
Edit by Caleb Fairres —
Edit approved by Caleb Fairres
- Before
- After
- Unchanged
Step Lines
| + | [title] Installing Connectors on Wires |
|---|---|
| + | [* 9] There are two different connectors. The off-white connectors in the DUET controller box are slightly different than the KK Molex (bright white) connectors SeeMeCNC installs on the wires. If you need to replace any terminals using the DUET supplied connectors, replace the enter end of the motor or switch. The crimp terminals are NOT interchangeable. |
| + | [* 10] ***IF THESE KK CONNECTORS ARE NOT WITH THE Z TOWER WIRE PACK, THEY WILL BE LOCATED IN THE DUET BOX SUPPLIED WITH YOUR PRINTER KIT.*** |
| + | [* 1] Remove the masking tape from the second set of wire on the pull wire. These are 26awg white wires for the heated bed thermistor. Polarity DOES NOT matter. Insert the wires into a 2 pin KK connector. NOTE: Polarity DOES NOT MATTER! |
| + | [* 1] When complete you will have 3 sets of wires on connectors: White and Black 26awg wires in a 4 pin KK connector, Red 26awg wire in a 2 pin KK connector, (2) White wires in a 2 pin KK connector. |
| + | [* 1] Check the image with the red circle to confirm that your Z tower wiring looks the same. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added