Changes to this Step
Edit by Caleb Fairres —
Edit approved by Caleb Fairres
- Before
- After
- Unchanged
Step Lines
| + | [title] Feeding More Z Tower Wires |
|---|---|
| + | [* 1] Now run the remaining wires. This is easiest using a piece of filament as a pull wire. |
| + | [* 9] ***Ensure that you have the orientation of the wires as specified in the photos, or you will have to remove the wires and re-feed them in the tower.*** |
| + | [* 1] Feed a piece of filament through the Z tower (tower that you just ran 18awg wires in) |
| + | [* 1] 3 inches lower you are going to tape the remaining wires (2-26awg white wires) to the pull wire. |
| + | [* 1] Next, gently pull the Pull Wire through the tower until you see the wires exit the top. If you feel any resistance, reverse approximately 25mm and then try gently pulling again. |
| + | [* 9] ***DO NOT REMOVE THE TAPE FROM THE WIRES / PULL WIRE*** |
Image 1
No previous image
Added